4
electric shock. Disconnect ap-
pliances from socket after use,
as well as during cleaning or
movement.
· Do not lay the power cord near
sharp corners and edges, close to
sources of heat (stoves, gas or
electric fryers). Do not immerse
into water appliance itself,
power cord or plug. This can
lead to malfunctions, which
are not covered by guarantee.
· It is prohibited to use the appli-
ance and packing materials for
children games. Do not leave
small children unattended
near the appliance during its
operation. Keep appliance in
place inaccessible for children.
· Do not allow to use appliance to
people with limited physical or
mental capabilities (including chil-
dren) before instructions for safe
use of the appliance is explained
to them and is understood by
them. The appliance may be
used 12 only under supervi-
sion of adults. Do not leave
the appliance connected to the
mains without attendance.
· It is prohibited to use appliance
outdoors. There is a danger of
fault due to rain or other
weather conditions.
· To provide safety during connect-
ing to the mains, the appliance
should be grounded. The appli-
ance should be connected only to
grounded sockets. Otherwise
the appliance will not corre-
spond to the requirements of
protection against electric
shock.
· Watch that the cord will not twist
and bend over the edge of table,
children contact it or stumble over
it. Place appliance only upon dry
even surface. Also observe gen-
erally accepted safety rules
during work with appliance.
· It is prohibited to use appliance
in case of any malfunctions. If it
is faulty or functions incor-
rectly, disconnect it from
mains, taking plug out of the
socket, and address the au-
thorized service center.
· Unassisted repair or modification
of appliance is prohibited. All
works related to maintenance and
repair should be carried out by
authorized service center. The
work carried out unprofes-
sionally can lead to fail, inju-
ries and property damage.
· Use the appliance for intended
purpose; it is prohibited to use it
for goals, not described in the
present manual. Do not use the
appliance in reservoirs that
are subjected to direct heat-
ing; and it is prohibited to
pour boiling liquid into bowls.
· The appliance may be used only
when it is completely assembled.
The appliance is to be used in
domestic conditions; the ap-
pliance is not designed for in-
dustrial use.
· Before cleaning the appliance
make sure that it is disconnected
from the mains and the appli-
ance's components rotation has
stopped completely. Always keep
the appliance clean. Keep this
Manual, so you can use it in
the course of consequent op-
eration.
· Use soapy water, sponge or soft
fabric Tor cleaning of the appli-
ance. Do not use chemical and
abrasive agents for cleaning.
· Do not touch hot details of a tea-
pot during its work or at once at
the work termination. It can lead
to a bum.
· Do not use any other network
cords except a cord which is de-
livered complete with the electro
device, and also do not use this
cord for other electric devices.
· If the electro device is not used,
take out a plug of a network cord
from the electric socket. Default
5
of this requirement can lead to
traumas, bums, defeat by an
electric current, or to current
leak, owing to damage of elec-
tric isolation.
· Service life – 2 years.
BEFORE USE
1. Carefully take the thermo pot out of the
box
2. Remove all packing materials, including
various stickers.
3. Clean the frame and base of the kettle
with wet cloth, then let it dry.
Before the first use fill and
boil the water. Than pour off
the water and repeat this ac-
tion two times.
II. OPERATION OF THE KETTLE
1. Establish the device on an equal surface
and insert a plug into the socket. At instal-
lation watch that hot steam at thermo pot
boiling did not get on furniture, home appli-
ances, walls etc.
2. Opening, removal and cover installation.
1. Lift the handle of opening of a cover.
2. Open a cover upwards. Keep the handle
of opening of a cover in the top position,
press the button of removal of a cover and
uncover at an angle upwards. For cover
installation into place execute actions for
cover removal in return sequence. For cov-
er closing press it from above before click.
3. First boiling.
Pour water in a thermo pot to a mark
"FULL" and close a cover.
Attention: In order to avoid a device over-
heat it is not recommended to pour less
than 0.5 I of water and above mark FULL.
In avoidance boil regularly add water.
4. Connect a food cord in the socket. The
thermo pot will join automatically; the boil-
ing indicator red colour thus will light up.
5. After water has begun to boil also a tea-
pot has passed in a "Keep warm" mode and
the indicator of green colour has lighted up,
press button "PRESS" and merge in such a
way half of water.
6. Then disconnect a power supplies, having
taken out a plug from the socket, discon-
nect a cord, uncover and merge the re-
mained water as is shown in drawing.
7. After that the teapot-thermos can use in
a usual mode. Pour fresh water to mark
FULL and connect a power cord in a net-
work. The teapot-thermos will join auto-
matically, the boiling indicator red colour