3Microlife NEB 210 EN
In case the power plug provided with the device does not fit your
wall socket, contact qualified personnel for a replacement plug
with that of a suitable one. In general, the use of adapters,
simple or multiple, and/or extension cables is not recom-
mended. If their use is indispensable, it is necessary to use
types complying with safety regulations, paying attention that
they do not exceed the maximum power limits, indicated on
adapters and extension cables.
Do not leave the unit plugged in when not in use; unplug the
device from the wall socket when it is not in operation.
The installation must be carried out according to the instructions
of the manufacturer. An improper installation can cause
damage to persons, animals or objects, for which the manufac-
turer cannot be held responsible.
Do not replace the power lead of this device. In case of a power
lead damage, contact a technical service center authorized by
the manufacturer for its replacement.
The power supply cord should always be fully unwound in order
to prevent dangerous overheating.
Before performing any maintenance or cleaning operation, turn
off the device and disconnect the plug from the main supply.
Only use the medication prescribed for you by your doctor and
follow your doctor's instructions with regard to dosage, duration
and frequency of the therapy.
Depending on the pathology, only use the treatment that is
recommended by your doctor.
Only use the nose piece if expressly indicated by your doctor,
paying special attention NEVER to introduce the bifurcations
into the nose, but only positioning them as close as possible.
Check in the medicine instruction leaflet for possible contraindi-
cations for use with common aerosol therapy systems.
Do not position the equipment so that it is difficult to operate the
disconnection device.
Nebuliser and accessories are single patient use. Device is
multi-patient use.
Never bend the nebuliser over 60°.
Do not use this device close to strong electromagnetic fields
such as mobile telephones or radio installations. Keep a
minimum distance of 3.3 m from such devices when using this
device.
2. Preparation and usage of this device
Prior to using the device for the first time, we recommend cleaning
it as described in the section «Cleaning and disinfecting»
1. Assemble the nebuliser kit AK. Ensure that all parts are
complete.
2. Fill the nebuliser with the inhalation solution as per your doctor’s
instructions. Ensure that you do not exceed the maximum level.
3. Connect the nebuliser with the air tube 6 to the compressor 1
and plug the power lead 2 into the socket (230 V 50 Hz AC).
4. To start the treatment, set ON/OFF switch 3 into the «I» posi-
tion.
The mouthpiece gives you a better drug delivery to the
lungs.
Choose between adult 8 or child face mask 9 and make
sure that it encloses the mouth and nose area completely.
Use all accessories including the nose piece AL as
prescribed by your doctor.
5. During inhalation, sit upright and relaxed at a table and not in an
armchair, in order to avoid compressing your respiratory
airways and impairing the treatment effectiveness. Do not lie
down while inhaling. Stop inhalation if you feel unwell.
6. After completing the inhalation period recommended by your
doctor, switch the ON/OFF switch 3 to position «O» to turn off
the device and unplug it from the socket.
7. Empty the remaining medication from the nebuliser and clean
the device as described in the section «Cleaning and disin-
fecting»
3. Cleaning and disinfecting
Thoroughly clean all components to remove medication residuals
and possible impurities after each treatment.
Ensure that children do not use this device unsupervised;
some parts are small enough to be swallowed. Be aware of
the risk of strangulation in case this device is supplied with
cables or tubes.
Use of this device is not intended as a substitute for a
consultation with your doctor.
This device was designed for intermittent use of 30
min. On / 30 min. Off. Switch off the device after 30 min.
use and wait for another 30 min. before you resume treat-
ment.
The device requires no calibration.
No modification to the device is permitted.