• The plug is not inserted or
incompletely inserted to the
socket
• Electrical power interruptions
• The set humidity level is
achieved
• The tank is full
• Too short time aer energi-
zation
• Air inlet/outlet of the appliance
is blocked
• Insuciently low humidity is set
• Windows or doors in the room
are not closed
• Temperature in the room is
below 5°C
• A wax heater or another source
of water vapor works in the
room
• The air lter is clogged
• The appliance is not installed
vertically
• The oor is not horizontal
• This is normal. The appliance
has an automatic thawing
system
• Malfunction of the temperature
sensor or humidity sensor
7. TROUBLESHOOTING
8. SERVICE LIFE
Service life of the appliance is 10 years provided that the respective installation and operation
rules are observed. Date of the conditioner manufacture is shown in a serial number of the
device. For more details, please, ask a shop assistant.
9. UTILIZATION RULES
Upon expiration of the service life, the appliance should be utilized in accordance with norms,
regulations and procedures eective in the place of utilization.
The appliance does
not work
Insucient output
The appliance works
too loudly
There is hoar frost on
the heat exchanger
The power indicator
blinks at the rate of 5
times per second
• Check connection to the mains
• Wait for recovery of electrical
power supply, contact the power
supplier
• Wait for increase of humidity in
the room
• Drain water from the tank
• Make sure that there are no
obstacles for air ow
• Select lower humidity on the
control panel
• Close windows and doors
• Wait until temperature rises
• Wait until the water vapor source
stops
• Flush the lter
• Install the appliance vertically
• Level the oor or move the appli-
ance to another location
• The appliance will automatically
switch to the thawing mode,
when necessary
• Remove the plug from the
socket and insert it again. If the
malfunction does not disappear,
contact the service center.
Failure Reason Remedy