10. HINTS AND TIPS
10.1 Ecological hints
• Spin the laundry well before drying.
• Do not exceed the load sizes which are
specified in the programs chapter.
• Clean the filter after each drying cycle.
• Do not use fabric softener to wash and
then dry. In the tumble dryer laundry
becomes soft automatically.
• Use distilled water like that used for
steam ironing. If it is necessary, clean
the distilled water before (e.g. with a
coffee filter) to remove any particles.
• Always keep the airflow slots at the
bottom of the appliance clear.
• Make sure there is good airflow where
the appliance is to be installed.
10.2 Adjustment of the
remaining laundry moisture
degree
To change the default degree of the
remaining moisture of the laundry:
1. Turn on the appliance.
2. Wait approximately 8 seconds.
3. Select 1 of available programmes.
4. Push at the same time and hold down
the
Half load and Cupboard
dry buttons.
One of the symbols goes into the view on
the display:
- the maximum dry laundry
- the more dry laundry
- the standard dry laundry
5. Push the Start/Pause button
again and again until you set
necessary degree.
6. To memorise the setting, push at the
same time the Half load and
Cupboard dry buttons for
approximately 2 seconds.
10.3 Deactivating the Reservoir
indicator
The water container indicator is by default
on. It starts to light at the end of the drying
cycle or during the cycle if the water
reservoir is full. If the draining kit is installed
the water container is drained
automatically and indicator can be
permanently off.
To deactivate the indicator:
1. Turn on the appliance.
2. Wait approximately 8 seconds.
3. Select 1 of available programmes.
4. Push at the same time and hold down
the
Half load and Iron dry
buttons.
One of 2 configurations is possible:
• the Reservoir indicator:
is on
and the symbol goes into
the view - the water container
indicator is permanently on
• the Reservoir indicator: is off
and the symbol goes into
the view - the water container
indicator is permanently off
11. CARE AND CLEANING
11.1 Cleaning the filter
At the end of each cycle the symbol
Filter is on the display and you must clean
the filter.
The symbol flashes on the
display - the filter is missing.
The tumble dryer cannot
start.
The filter collects the fluff. The
fluff occurs while the clothes
are dried in the tumble dryer.
To clean the filter:
1. Open the door. Pull the filter.
ENGLISH
15