Reset
Reset your Web Presenter HD by clicking the ‘factory reset’ button.
Network Settings
Your Web Presenter HD can connect to the network using a static IP address or by using DHCP.
DHCP - will automatically set an IP address for your unit and connect it to your network without
any settings changed.
The dynamic host configuration protocol, or DHCP, is a service on network servers and routers
that automatically finds your Web Presenter HD and assigns an IP address. DHCP makes it easy
to connect equipment via Ethernet and make sure that IP addresses do not conflict with each
other. Most computers and network switches support DHCP.
Static IP - If you want to set the IP address yourself, simply set the protocol setting to ‘static IP’
and change the IP settings manually.
A static IP address is one that won’t change even if your Web Presenter HD is rebooted.
Using a static IP address might be necessary if your connecting your Web Presenter HD to a
corporate network. If you have a network administrator, it’s possible your network might have
custom IP addresses for all the equipment connected to it. It’s best to check with your network
administrator if they are managing your computers and network in your company.
Setting Internet Sharing
forDirectStreaming
If you are unable to plug Web Presenter HD directly into a network switch or internet router,
youcan share your computer’s internet connection with Web Presenter HD through its
Ethernet port.
To set up Blackmagic Web Presenter HD for direct streaming:
1 Set your Web Presenter HD to use DHCP.
2 Configure your computer to share its internet connection through its Ethernet port.
Mac: in System Preferences, click ‘sharing’ then select ‘internet sharing’ from the
‘service’ list. In the ‘share your connection from’ menu, choose ‘wi-fi’ if your Mac is
connected to the internet over wifi. In the ‘to computers using’ list, select ‘ethernet’.
Inthe ‘service’ list, tick the ‘internet sharing’ checkbox. When you are asked if you are
sure you want to turn on internet sharing, click ‘start’.
Windows: right click the ‘start’ icon and select ‘network connections’. The ‘network
status’ screen appears. Click on ‘change adapter options’. This lists your computer’s
network connections. Right click on the internet connection and select ‘properties’.
Onthe ‘sharing’ tab, tick ‘allow other network users to connect through this computer’s
internet connection’. Select a network connection in the menu then click ‘OK’.
3 Plug Web Presenter HD into your computer’s Ethernet port. After a few seconds,
DHCPassigns an IP address to Web Presenter HD.
4 Confirm your Web Presenter HD is connected to the internet via Ethernet by observing
Ethernet icon in the top right corner on the unit’s LCD screen.
18Setting Internet Sharing forDirectStreaming