ENGLISH en
9
Original instructions
We, being solely responsible: Hereby declare that
these paint removers, identified by type and serial
number *1), meet all relevant requirements of
directives *2) and standards *3). technical
documents for *4) - see Page 3.
The paint remover is suitable for the machining of
painted and unpainted wooden surfaces.
The user bears sole responsibility for any damage
caused by inappropriate use.
Generally accepted accident prevention
regulations and the enclosed safety information
must be observed.
For your own protection and for the
protection of your power tool, pay
attention to all parts of the text that are
marked with this symbol!
WARNING – Reading the operating
instructions will reduce the risk of injury.
WARNING Read all safety warnings and
instructions. Failure to follow all safety
warnings and instructions may result in electric
shock, fire and/or serious injury.
Keep all safety instructions and information for
future reference.
Pass on your power tool only together with these
documents.
Hold power tool by insulated gripping
surfaces, because the cutter head may contact
its own cord. Cutting accessory contacting a "live"
wire may make exposed metal parts of the power
tool "live" and shock the operator.
Wait until the cutter head is at a standstill
before setting down the power tool. An exposed
cutter head can get caught on the surface and lead
to a loss of control and possible serious injury.
Do not place the device on hard surfaces to protect
the reversible cutting plates.
Always wear personal protective equipment, safety
goggles, ear protectors, protective gloves and
heavy-duty footwear during work and for all setting,
conversion and maintenance tasks!
Danger of injury from the sharp
edges of the reversible blades. Pay
attention to the rotating cutter head!
Keep in mind that the motor and thus
the cutter head of your paint remover
continues to run after switching off the tool.
Avoid inadvertent starts: always switch the tool off
when the plug is removed from the mains socket or
if there has been a power cut.
Turn/replace blunt reversible blades in good time:
Worn cutting edges of the reversible blades
increase the risk of kickback and reduce the quality
of the milling operation.
Turn/replace blunt reversible blades always in
pairs.
Do not machine any workpiece surfaces that
contain nails, screws or similar obstacles!
The workpiece must lay flat and be secured against
slipping, e.g. using clamps.
Secure small workpieces. For example, clamp in a
vice.
Opening the protective flaps:
Attention: Danger of injury from the
sharp edges of the blades! Switch off the
machine. The cutter head has to be idle!
A: Open the protective flap as shown and
B: fold all the way upwards.
Protective flaps:
All protective flaps have to be closed during surface
milling operations.
During peripheral milling (e.g. at folds) open only
the protective flap pointing towards the workpiece.
High forces are released if the tool jams or catches.
You must therefore always hold the machine with
both hands using the handles provided, assume a
safer stance and concentrate while working.
Reduce dust exposure:
Some dust created by using this power tool
may contain chemicals known to cause
cancer, allergic reaction, respiratory disease, birth
defects or other reproductive harm. Some
examples of such substances are, lead (in paint
containing lead), additives used for wood treatment
(chromate, wood preservatives), some wood types
(such as oak or beech dust).
The risk from these exposures depends on how
long you or bystanders are being exposed.
Do not let particles enter the body.
To reduce your exposure to these chemicals: work
in a well ventilated area, and work with approved
1. Declaration of Conformity
2. Specified Use
3. General Safety Instructions
4. Special Safety Instructions
