There are 2 clips installed behind the
unit for fixing to the wall. These clips
must be fixed plastic thumbscrew on
the product with the same distance as
the distance of wall-mounting. 2
mounting apparatus are included in
the package with the product. These
clips must be attached to other clipses
on the product fixed with bolt and nut.
Then the product is inserted in
suitable points drilled for hanging on
the wall and so wall mounting has
been completed. The unit must be
parallel with the floor completely
at this moment.
Electrical connection required for wall
mounting (if it is operated without any
cables or cords) must be performed by
authorized service employee.
Please consider the following warnings
for electrical connection required for
wall mounting without any cables or
cords:
Electrical connection
Insert the plug into socket by paying
attention to Marks "L" and “N".
Connect it to the grounded plug for
your own safety. Then adjust the
heater upwards. Find the best angle
and tighten the screws.
Operating
Turn the thermostat switch to max or
min. Position to turn on or turn off the
unit. To benefit from the unit at
optimum level, ensure that it is
mounted in correct place and operated
in proper environments. (If the healer
is used in internal areas, heating areas
must not be exposed to open areas
such as window, balcony), if the unit
is not operated for a long time or
while replacing the unit, the cable or
cord must be plug.
Note: In the models with On-Off
button, use button of your heater
to run it. When the thermostat button
is set to the desired temperature
degree, it will activate with half-power
and full-power in order to fix room
temperature. In this way, more
economic heating is passible by
achieving energy saving.
Authorized service
The unit does not additional spare
parts other than mounting apparatus.
For this reason, contact with your
dealer for damages and for repairs
being within the scope of warranty.
CLEANING
The unit should be cleaned with soft
cloth damped with cleaning agent.
Never use flammable, combustible
chemicals such as spirit and similar
agents for the purpose of cleaning.
OPERATION AND MAINTENANCE
OF THE UNIT
Read the safety instructions for long
service life of your heater. Never
operate your heater in vertical
position, do not replace while
operating. If you encounter with cord
failure or any problems in your heater,
contact with our authorized service
immediately. Do not attempt to repair
your heater yourself or get it repaired
by unauthorized persons. Failures
arising from intervention of
unauthorized persons or use mistakes
are not included within the scope of
warranty. Our company is not liable
for such failures. In these cases, even
if warranty period does not expire,
warranty will be void. We recommend
you long-handled and thing duster
brush for your unit depending on dust
and dirt amount. When the unit is
opened by authorized personnel for
any purpose, it can be cleaned with
damp cloth not leaving pile. The
heater must not be cleaned with
flammable, combustible materials for
the purpose of cleaning. While it is
operating, do not cover your heater.
This may cause overheating and thus
possibility of fire hazard. If you intend
not to operate your heater for a long
time, it is recommended to plug it out
and wrap carefully and store in a dry
floor suitable for you at horizontal
position.
MEASURES TO BE TAKEN FOR
EFFICIENT ENERGY USE WHILE
OPERATING YOUR HEATER
Please observe the following
recommendations to use your heater
efficiently in for the energy
consumption and therefore to save
country energy,
1. Operate your heater for
heating environments with heating
purpose if possible. Do not misuse it
(drying objects, cooking),
2. Do not place objects that will
prevent operating and/or cause over
heating in front of the heater.
3. The heater should have a
special bimetal thermostat. Your
heater has such thermostat and
it switches off your heater
automatically when adjusted
temperature has been reached and it
works again if the ambient
temperature fall below the
temperature adjusted. So electricity
waste is prevented.