AC12 Compliance Insert
For Users in the United States and Canada
The users of this product are cautioned to use accessories and peripherals approved by Intermec Technologies Corporation. The use of
accessories other than those recommended, or changes to this product that are not approved by Intermec Technologies Corporation, may
void the compliance of this product and may result in the loss of the user’s authority to operate the equipment.
FCC Digital Emissions Compliance
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the radio or television receiving antenna.
• Increase the separation between the computer equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the radio or television receiver is connected.
• Consult the dealer or an experienced radio television technician for help.
Canadian Digital Apparatus Compliance
This Class B digital apparatus meets all requirements of the Canadian Interference-Causing Equipment Regulations.
Conformité aux normes canadiennes sur les appareils numériques
Cet appareil numérique de la classe B respecte toutes les exigences du Réglement sur le matériel brouilleur du Canada.
Battery Information
Battery Recycling Information
Note: In the U.S.A., the EPA does not consider spent Li-ion batteries as hazardous waste.
Caution: This marking indicates that the user should read all included documentation before use.
Attention: Ce marquage indique que l’usager doit, avant l’utilisation, lire toute la documentation incluse.
Caution: For use with Intermec battery pack Model AB12 only. For power supply, use Intermec Model 851-061-102. No
user-serviceable parts.
Attention: Pour utilisation suelement avec bloc-batterie Intermec modèle AB12. Pour la source d’alimentation, utilisez
Intermec modèle 851-061-102. Il ne contient aucune pièce réparable par l’utilisateur.
Caution: The battery pack used in this device may ignite, create a chemical burn hazard, explode, or release toxic
materials if mistreated. Do not incinerate, disassemble, or heat above 100°C (212°F). Do not short circuit; may cause
burns. Keep away from children.
Use only Intermec battery pack Model AB12. Risk of fire or explosion if incorrect battery pack is used. Promptly dispose
of used battery pack according to the instructions.
Attention: Le bloc-piles utilisé dans cet appareil peut prendre feu, constituer un risque de brûlure chimique, exploser ou
dégager des substances toxiques s’il est manipulé de façon inappropriée. Ne pas jeter au feu, démonter ou chauffer à plus
de 100°C (212°F). Ne pas court-circuiter; cela pourrait causer des brûlures. Garder hors de la portée des enfants.
N’utiliser que le modèle de bloc-piles Intermec modèle AB12. L’utilisation d’un mauvais bloc-piles pourrait constituer un
risque d’incendie ou d’explosion. Mettre rapidement au rebut tout bloc-piles usé, conformément aux instructions.
Li-ionLi-ion
This product contains or uses a lithium ion (Li-ion) main battery. When the battery reaches the end of its useful life, the
spent battery should be disposed of by a qualified recycler or hazardous materials handler. Do not mix this battery with the
solid waste stream. Contact your Intermec Technologies Service Center for recycling or disposal information.
Ce produit contient ou utilise une pile principale au lithium-ion (Li-ion). Lorsque la batterie atteint la fin de sa durée de
vie utile, la batterie usées doivent être mises aux rebuts par un agent de recyclage ou un manipulateur de matériaux
dangereux agréé. Il ne faut pas mélanger la batterie aux autres déchets solides. Pour plus d’informations sur le recyclage ou
la mise aux rebuts, contacter votre centre de services Intermec Technologies.