11
en
Use
Some programmes consist of several
programme steps. The respective
programme step is shown in the display.
Once a step is finished, a recurring signal
tone sounds and the display and button
G flash. Add ingredients depending on
the recipe, and press button G again. The
following preparation step will start.
Depending on the programme selection
or the preparation step, the lid should be
closed or open. Please see the AutoCook
app for more details here.
Selecting and starting the
programme
Warning!
– Do not fill the pan beyond the marking
[4.0 litres]!
– Use only plastic utensils for stirring (do
not use metal utensils).
Important: Take note of the safety
instructions at the beginning of the manual.
X Image sequence E
1. Keep pressing button D until the
desired preparation programme is
selected. The corresponding LED
lights up in the control panel and the
pre-configured preparation time for
the selected preparation programme
flashes.
2. Press button E to change the
pre-configured preparation time.
The display changes from [средняя]
(medium) to [длинная] (long) and then
to [короткая] (short) before returning to
[средняя] (medium). The pre-configured
preparation time is shown in the display.
3. Open the lid and add the required
ingredients depending on the recipe.
4. Depending on the preparation
programme, close the lid.
5. Press button G to start the preparation
programme.
6. The appliance heats up the pan until the
target temperature is reached. During
the heating phase, lines that light up
in a clockwise direction appear in the
display.
7. Once the target temperature is reached,
the lines go out and the remaining
preparation time is shown in the display.
Note: For programmes with several
preparation steps, once the target
temperature has been reached or once the
preparation step is completed, a signal tone
sounds. Add further ingredients and press
button G to start the next preparation step.
8. When the preparation programme ends,
a signal tone sounds, and the indicator
[готово] (finished) and button G light
up. The display flashes and shows
“00:00”.
Note: For some programmes, once
complete, the keep warm function is
automatically activated. The indicator
[подогрев] (keep warm) lights up.
9. Press button B to switch to standby
mode. Disconnect the mains plug.
10. Serve the finished dish and let the
appliance cool down completely.
■ Once it has cooled down completely,
clean all of the parts. X “Cleaning and
maintenance” see page 14
Prematurely terminating the
current preparation step
If the ingredients are cooked ahead of time
during one of the preparation steps, the
step can also be terminated manually.
■ Press button G for at least 2 seconds.
■ This will terminate the current
preparation step. A signal tone will then
sound once the next step can be carried
out.
■ In the control panel, LEDs 1, 2, 3 or 4
are shown accordingly and button G
flashes.
■ Press button G to start the next
preparation step.
Prematurely terminating the
preparation programme
■ Press button H to end the preparation
programme.