GR-F419SLQK

LG GR-F419SLQK Инструкция по применению

  • Здравствуйте! Я ознакомился с инструкцией по эксплуатации холодильника LG. Готов ответить на ваши вопросы о его функциях, установке, уходе и решении возможных проблем. В руководстве описаны такие полезные функции, как регулировка температуры, быстрая заморозка и энергосберегающий режим. Задавайте ваши вопросы!
  • Что делать, если холодильник не работает?
    Как быстро заморозить продукты?
    Как перенавесить двери холодильника?
    Что делать, если слышен шум от компрессора?
ENGLISH
Rehinging of doors
Disposal of your old appliance
3
CARE AND
MAINTENANCE
Trouble Shooting
Smart Diagnosis
REHINGING OF DOORS
Connection
Operation
Introduction
Identification of Parts
Installation
Connection
General
Cleaning
Important Safety Instruction
Registration
Refrigerator operation features
Trouble Shooting
Control panel
• Quick freeze
• ECO Mode
• Loose-fitting door alarm
Removal and installation of drawer in refrigeration
comparment
Foodstuff storage
Ice preparation
Removal and installation of drawer in freezing comparment
Removal and installation of detachable glass shelf
Water Dispenser
• Temperature control
• Self-test
12
12
13
13
15
4
4
9
10
10
14
• “Lock” (For models with LED dispaly)
14
14
15
14
16
16
17
Energy-Saving Method
17
17
18
18
19
21
22
SMART DIAGNOSIS(OPTION)
23
11
Figure 1. Installation of limit stops
Figure 2. Installation of refrigerator to wall
The limit stops are located in the door basket of the
refrigeration compartment.
They should be installed to get higher operational efficiency
of the refrigerator.
Connection
forward backward
NOTE
REMOVAL AND INSTALLATION OF
If the water level is lower than the line, there
may have residual water or water flow when
dispensing water, please add water in the
tank in time.
water level
16
When a large quantity of foodstuffs is stored
in the freezing compartment, you can remove
the middle drawer from the appliance and
store foodstuffs immediately on foodstuffs
placed to the lower drawer.
To remove any drawer of the freezing
compartment, proceed as follows:
1. Pull the drawer all the way out;
2. Raise it by the front part and pull.
DRAWERS IN FREEZING COMPARTMENT
CAUTION!
To install any drawer back to the freezing
compartment, proceed in the reverse
sequence:
1. Place the drawer onto the guides at
an angle 45°;
2. Lower the front part of the drawer in
parallel to the guides;
3. Push the drawer all the way in.
At that, you should take care to exclude
slant.
Do not apply excessive force to remove the
drawers and shelves – this may result in
damage of the refrigerator.
2
3
1
1
2
ICE PREPARATION
Fill the ice tray with water and place it to
the freezing compartment.
To remove ice cubes, hold the tray on ends
and slightly bend it.
Fill with potable water only.
If ice cubes are required as soon as possible,
activate the "QUICK FREEZE" function.
Operation
To easily remove cubes, water the tray in
advance.
WARNING
REMOVAL AND INSTALLATION OF
ADVICE
18
GENERAL
Electric power failure.
• An interruption in electric power supply for
1-2 hours will not harm the stored foodstuffs.
Try to less frequently open and close the
refrigerator door during this period.
DURING MOVE:
• Remove all foodstuffs and other objects
from the refrigerator. Firmly secure the
internal detachable parts
(shelves, drawers, door baskets);
• To avoid damage of the floor and adjustable
feet of the refrigerator, turn them
counter-clockwise before transportation;
• The refrigerator should be firmly secured in
the truck to prevent its hits and falling
inside the truck during transportation;
• The refrigerator should be transported in
vertical position in a covered vehicle.
The original package should not be
damaged during transportation;
• During loading and unloading, the
refrigerator should be protected against hits.
BEFORE SWITCHING ON:
• If the refrigerator is transported in cold
season, unpack the refrigerator in a warm
room and do not switch on it for at least
12 hours.
ANTI-CONDENSATION TUBE:
• The anti-condensation tube is laid inside
the enclosure around the front face of the
refrigerator to exclude moisture
condensation;
• The refrigerator may greatly heat up in
these places, especially immediately after
switching on for the first time or at high
ambient temperature.
Anti-condensation tube
REFRIGERATOR OPERATION
FEATURES
Cracking noise may be heard due to thermal
deformations of the refrigerator components.
Typical sounds from activation of the
thermostatic controller and compressor are
normal sounds occurring during operation of
electric equipment in the appliance.
The refrigerant circulating inside the
refrigeration system may calmly gurgle,
even if the compressor is idle.
Do not worry, this is absolutely normal.
The following sounds may be heard during
operation of the refrigerator:
- Clicks from actuation of the temperature
sensor/switch;
- Murmur of the refrigerant circulating in tubes
of the refrigeration system;
- Slight cracking noise from thermal
deformations of materials.
These sounds are not associated with any
defect and they have a functional aspect.
CAUTION!
Do not move or incline the refrigerator during
its operation.
Noise may occur in the compressor.
This feature does not affect operability of
the compressor.
CARE AND MAINTENANCE
21
Before calling for service, check this list.
It may save you both time and expense.
This list includes common occurrences that are not the result of defective workmanship
or materials in this appliance.
Problem Possible Causes
Moisture
forms on Cabinet Surface
Fridge-Freezerdoes
not operate
Fridge or Freezer
Compartment
Temperature too warm
Vibration or Rattling
or Abnormal Noise
Power plug may be unplugged from the electricoutlet.
Plug it in securely.
House fuse has blown or circuit breaker hastripped.
Check and/or replace fuse and reset circuit breaker.
Power cut.
Appliance is placed close to heat source.
Warm weather-frequent door openings.
Door left open for a long time.
Check house lights.
Make it even by rotating the leveling screw.
Refer to Temperature Control section.
Temperature control not set on proper position.
Package holding door open or blocking air
duct in freezer compartment.
The floor on which the fridge-freezer is installed may
be uneven or the fridge-freezer may beunstable.
Unnecessary objects placed in the back side of
the fridge-freezer.
Door may have been left ajar or package holding
door open.
Too frequent or too long door openings.
Frost within package is normal.
This phenomenon is likely to occur in a wet space.
Frost or IceCrystals
on frozenFood
Moisture collects inside • Too frequent or too long door openings.
• In humid weather, air carries moisture into
fridge when doors are opened.
Wipe it with a dry towel.
Trouble Shooting
/