Philips HX9911/29 Руководство пользователя

DiamondClean

9000

4

3

5

6

8

12

14

13

11

10

7

9

1

2

1

English 6

Русский 31

Қазақша

58

English

Introduction

Congratulations on your new Philips Sonicare power toothbrush!

Superior plaque removal, whiter teeth and healthier gums are at your

fingertips. Using Sonicare’s combination of gentle sonic technology

and clinically developed and proven features, you can be confident

that you’re getting the very best clean, every time. Further support

and product registration are available to you at:

http://www.philips.com/welcome.

Welcome to the Philips Sonicare family!

Intended Use

DiamondClean series power toothbrushes are intended to remove

adherent plaque and food debris from the teeth to reduce tooth

decay and improve and maintain oral health. DiamondClean series

power toothbrushes are intended for consumer home use. Use by

children should be with adult supervision.

Important safety information

Read this important information carefully before you use the

appliance and save it for future reference.

Note: The accessories and features of different models vary. For

example, some models come with a sanitizer or are not equipped

with Bluetooth. For the accessories, basic parameters and

characteristics of your model, see the supplement to the user manual.

Danger

- Keep the charger and/or sanitizer away

from water. Do not place or store the

appliance where it can fall or be pulled into

a tub or sink.

- Do not immerse the charger and/or sanitizer

in water or any other liquid.

6

English

- After cleaning, make sure the charger

and/or sanitizer is completely dry before

you connect it to the wall socket.

Warning

- This appliance can be used by children and

persons with reduced physical, sensory or

mental capabilities or lack of experience

and knowledge if they have been given

supervision or instruction concerning use of

the appliance in a safe way and understand

the hazards involved. Cleaning and user

maintenance shall not be made by children

without supervision.

- Children shall not play with the appliance.

- If the appliance is damaged in any way

(brush head, toothbrush handle, charger

and/or sanitizer), stop using it.

- The mains cord cannot be replaced. If the

mains cord is damaged, discard the charger

and/or sanitizer.

- Always replace the charger and/or sanitizer

with one of the original type in order to

avoid a hazard.

7

English

- This appliance contains no user-serviceable

parts. If the appliance is damaged, contact

the Consumer Care Center in your country

(see 'Warranty and support').

- Keep the cord away from heated surfaces.

- Do not use the charger and/or sanitizer

outdoors or near heated surfaces.

Caution

- Do not clean the brush head, handle,

charger, charger cover or sanitizer in the

dishwasher.

- If you have had oral or gum surgery in the

previous 2 months, consult your dentist

before you use this appliance.

- Consult your dentist if excessive bleeding

occurs after using this appliance or if

bleeding continues to occur after 1 week of

use. Also consult your dentist if you

experience discomfort or pain when you use

this appliance.

8

English

- This Philips appliance complies with the

safety standards for electromagnetic

devices. If you have a pacemaker or other

implanted device, contact your doctor or the

appliance manufacturer of the implanted

appliance prior to use.

- If you have medical concerns, consult your

doctor before you use this appliance.

- This appliance has only been designed for

cleaning teeth, gums and tongue. Do not

use it for any other purpose. Stop using the

appliance and contact your doctor if you

experience any discomfort or pain.

- This appliance is a personal care device and

is not intended for use on multiple patients

in a dental practice or institution.

- Do not use other brush heads than the ones

recommended by Philips Sonicare.

- Stop using a brush head with crushed or

bent bristles. Replace the brush head every

3 months or sooner if signs of wear appear.

9

English

- If your toothpaste contains peroxide, baking

soda or bicarbonate (common in whitening

toothpastes), thoroughly clean the brush

head with soap and water after each use.

This prevents possible cracking of the

plastic.

- Avoid direct contact with products that

contain essential oils or coconut oil. Contact

may result in bristle tufts dislodging.

Electromagnetic fields (EMF)

This Philips appliance complies with all applicable standards and

regulations regarding exposure to electromagnetic fields.

Radio Equipment Directive

Hereby, Philips declares that electric toothbrushes with radio

frequency interface (Bluetooth) are in compliance with Directive

2014/53/EU.

The full text of the EU declaration of conformity is available at the

following internet address: www.philips.com/support

The radio frequency interface in this product operates at 13.56MHz.

The maximum RF power transmitted by the appliance is 30.16dBm.

Your Philips Sonicare (Fig. 1)

1 Hygienic travel cap

2 Smart brush heads*

3 Handle

4 Power on/off button

5 Intensity light

6 Mode/intensity button

7 Modes

8 Brush head replacement reminder light

10

English

9 Battery indication

10 Charging glass

11 Charging stand

12 Charging base

13 (Charging)Travel case*

14 USB wall adapter*

Note: The content of the box may vary based on the model

purchased, see the supplement to the user manual.

Sonicare app – Getting Started

The Sonicare app pairs with your toothbrush to provide you a

connected experience. By connecting your toothbrush to your

Sonicare app account, you will be able to:

- Easily review your progress report for ways to improve your

brushing routine

- Receive personalized tips and recommendations for managing

your oral health

To start using the Sonicare app:

1 Download the Sonicare app to your phone

2 Open the app and follow the guided steps

3 Pair your toothbrush with the app

4 Create your account

5 Complete firmware update, if prompted, to access the latest

improvements and features.

6 Brush regularly

You are ready to start your connected experience. Be sure to brush

regularly. You can receive updates to help improve your oral

healthcare.

Note: Make sure your phone’s Bluetooth is turned on when using the

app. Your toothbrush uses the Bluetooth connection to transfer your

brushing data to the app. If you have questions about why your

brushing data is collected, be sure to review the Sonicare Privacy

Statement, available throughout the app setup process.

11

English

Sonicare app – Track and improve your oral health

care

Your Sonicare power toothbrush is equipped with smart sensors to

provide you with feedback about your brushing habits, including:

- Daily brushing sessions

- Time spent during each brushing session

- Applied brushing pressure

- Brush head replacement reminder (based on actual use)

The Sonicare app collects the data provided by the smart sensors

and tracks your brushing habits over time.

Each of the features available in the app are designed to help you

understand your brushing habits and provide you with simple

recommendations for improving and maintaining your oral health.

You will receive personalized brushing information in the Sonicare

app.

Brush heads

To see what type of brush head you have, check the label at the

bottom of the brush head. The symbol at the bottom of the brush

head indicates that it is a smart brush head, equipped with the

BrushSync technology.

Brush head

name

Premium

Plaque

Defence

Premium White Premium Gum

Care

Brush head

label

C3 W3 G3

12

English

Benefit

Plaque removal Plaque and

stain removal

Healthier gums

To explore our full range of brush heads, go to

www.philips.com/toothbrush-heads for more information.

Using your Philips Sonicare

Brushing instructions

1 Push the brush head firmly onto the handle. Wet the bristles and

apply toothpaste.

Note: It is normal to see a slight gap between the brush head and

the handle. This allows the brush head to vibrate properly.

2 Place the toothbrush bristles against the teeth at a slight angle (45

degrees), apply light pressure to make the bristles reach the

gumline or slightly beneath the gumline.

Note: Keep the center of the brush head in contact with the teeth

at all times.

3 Press the power on/off button to turn on the Philips Sonicare.

45°

13

English

4 Apply light pressure to maximize Philips Sonicare’s effectiveness

and let the Philips Sonicare toothbrush do the brushing for you.

Gently move the brush head slowly across the teeth in a small

back and forth motion so the longer bristles reach between your

teeth. Continue this motion throughout the brushing cycle.

Note: Different modes are available (see 'Brushing modes').

5 To clean the inside surfaces of the front teeth, tilt the brush handle

semi-upright and make several vertical overlapping brushing

strokes on each tooth.

Note:

- A change in vibration from the handle alerts you when you apply

too much pressure (see 'Pressure sensor').

- Your Philips Sonicare toothbrush is safe to use on braces, dental

modifications and dental restorations (fillings, crowns, veneers)

- Do not use your power toothbrush in the shower.

BrushSync technology

BrushSync technology enables your brush heads to communicate

with your handle using a microchip. The symbol at the bottom of the

14

English

brush head indicates that it is equipped with the BrushSync

technology. This enables the following features:

- Brush head mode pairing

- Brush head replacement reminder

Brushing modes

Your power toothbrush is equipped with 4 different modes: clean,

white+, gum health and deep clean+.

Based on the smart brush head you use, the optimal mode and

intensity will be selected automatically by the BrushSync technology.

To manually change the mode, press the mode/intensity button while

the toothbrush is off with the brush head attached.

* Note:

- All brush heads work with each mode.

- When the Philips Sonicare toothbrush is used in clinical studies, it

must be used at high intensity, with the EasyStart feature turned off.

Brush head mode pairing

Brush heads with BrushSync technology are equipped with a

microchip which communicates to the handle and automatically pairs

it with the recommended mode and intensity.

Note:If you change modes/intensity, the brush head will remember

the last used setting. If you wish to brush with the recommended

setting, you can find the recommended mode/intensity in the

following table.

15

English

clean and deep

clean+

white+ gum health

Benefit

Plaque removal Plaque and

surface stains

removal

Plaque removal

and gum

massage

Recommended

brush head

Premium

Plaque

Defence (C3)

Premium White

(W3)

Premium Gum

Care (G3)

Recommended

intensity level

3 3 3

Total brushing

time

clean: 2

minutes

deep clean+: 3

minutes*

2 minutes and

40 seconds

3 minutes and

20 seconds

16

English

clean and deep

clean+

white+ gum health

How to brush

clean: Brush

each segment

for 20 seconds

1

2

3

4

5

6

deep clean+:

Brush each

segment for 30

seconds*

1

2

3

4

5

6

Brush each

segment for 20

seconds,

1

2

3

4

5

6

then brush

segments 7 and

8 for 20

seconds each.

7

8

Brush each

segment for 20

seconds,

1

2

3

4

5

6

then brush

segments 7, 8,

9 and 10 for 20

seconds each.

7

8

10

9

*Note: When brushing with the Sonicare app in 'deep clean+' mode,

the brushing time will be 2 minutes.

Intensity settings

Your power toothbrush comes with 3 different intensity settings:

- low intensity (one bar)

- medium intensity (two bars)

- high intensity (three bars)

17

English

When attached to the handle, the smart brush head will automatically

select the recommended intensity. To manually change the intensity,

turn on the handle and press the mode/intensity button.

While toothbrush is

ON, press this

button to change

the intensity setting

Features

- BrushPacer

- Pressure sensor

- Brush head replacement reminder

- EasyStart

BrushPacer

The BrushPacer features indicates when you have to move to the

next section of your teeth with a brief change in vibration.

The toothbrush turns off automatically at the end of the brushing

session.

Pressure sensor

Your Philips Sonicare measures the pressure you apply while

brushing to protect your gums and teeth from damage.

If you apply too much pressure, the handle will change its vibration

until you reduce the pressure.

Note: The Pressure Sensor comes activated with your product. To

deactivate this feature, see 'Activating or deactivating features'.

Brush head replacement reminder

Over time, the handle will track the wear of your smart brush head by

measuring:

18

English

- The overall pressure you apply while brushing

- The total time you have brushed with your brush head

Once your brush head is no longer effective, the brush head

replacement reminder will blink amber and the handle will make a

series of beeps and tones.

Note: The brush head replacement reminder comes activated with

your product. To deactivate this feature, see 'Activating or

deactivating features'.

EasyStart

The EasyStart feature gently increases the power of the handle over

the first 14 brushings to help you get used to the brushing power of

the Philips Sonicare.

The EasyStart feature works with all modes.

Note: The EasyStart feature comes deactivated with your product. To

activate EasyStart, see 'Activating or deactivating features'.

Charging and battery status

Charging on charger base

1 Plug the cord of the charging base into an electrical outlet.

2 Place the charging stand or the charging glass on the charging

base.

19

English

3 Place the handle on the charging stand or in the charging glass.

4 The charger will charge your toothbrush until it is fully charged.

The handle is charging when the battery indication is blinking white.

When the handle is fully charged, the battery indication illuminates

white for 30 seconds and then turns off.

Note: Your handle comes pre-charged for first use. After first use,

charge for at least 24 hours.

Charging with the travel case*

*Note: The charging travel case may not be included depending on

the model purchased.

1 Take the USB cable from the bottom of the charging travel case.

2 Connect the charging travel case to 5V DC input power either from:

-

The USB adapter provided

-

a UL-listed or certified to ANSI/UL 60950-1 personal

computer's standard USB connector or,

-

a UL-listed or certified to ANSI/UL 60950-1 LPS power supply

with USB output port or,

20

English

Страница загружается...

Philips HX9911/29 Руководство пользователя

Похожие модели бренда

Модели других брендов