Yamaha Soavo-900C Инструкция по применению

English

Français

Deutsch

Español

Read this before using the speaker.

•To assure the finest performance, please read this

manual carefully. Keep it in a safe place for future

reference.

• Install the speaker in a cool, dry, clean place – away

from windows, heat sources, sources of excessive

vibration, dust, moisture and cold. Avoid sources of

humming (transformers, motors). To prevent fire or

electrical shock, do not expose the speaker to rain or

water.

•To prevent the enclosure from warping or discoloring, do

not place the speaker where it will be exposed to direct

sunlight or excessive humidity.

• Do not place the following objects on the speaker:

Glass, china, etc.

If glass etc. falls by vibrations and breaks, it may cause

personal injury.

A burning candle etc.

If the candle falls by vibrations, it may cause fire and

personal injury.

A vessel with water in it

If the vessel falls by vibrations and water spills, it may

cause damage to the speaker, and/or you may get an

electric shock.

• Do not place the speaker where foreign objects such as

water drips might fall. It might cause a fire, damage to

the speaker, and/or personal injury.

PRECAUTIONS

Soavo-900C

Speaker System

OWNER’S MANUAL

URGT

Thank you for selecting this YAMAHA Soavo-900C speaker system.

• Do not place the speaker where it is liable to be knocked

over or struck by falling objects. Stable placement will

also ensure better sound performance.

• Placing the speaker on the same shelf or rack as the

turntable can result in feedback.

• Never put a hand or a foreign object into the port located

on the rear of the speaker as this might cause personal

injury and/or damage to the speaker.

• When moving the speaker, do not hold the port as it

might cause personal injury and/or damage to the

speaker.

• Any time you note distortion, reduce the volume control

on your amplifier to a lower setting. Never allow your

amplifier to be driven into “clipping”. Otherwise the

speaker may be damaged.

• When using an amplifier with a rated output power

higher than the nominal input power of the speaker, care

should be taken never to exceed the speaker’s

maximum input.

• Do not attempt to clean the speaker with chemical

solvents as this might damage the finish. Use a clean,

dry cloth.

• Do not attempt to modify or fix the speaker. Contact

qualified YAMAHA service personnel when any service

is needed. The cabinet should never be opened for any

reasons.

• Secure placement or installation is the owner’s

responsibility.

YAMAHA shall not be liable for any accident caused

by improper placement or installation of the speaker.

01_En_Soavo-900C_URGT.p65 7/31/06, 9:11 AM1

PLACING THE SPEAKER

Place the speaker on top of the TV or inside the TV rack so

that the speaker and TV are aligned vertically.

Notes

•

Do not place the speaker on top of the TV whose area is

smaller than the bottom area of the speaker. If placed,

the speaker may fall and cause injury.

• Do not place the speaker on top of the TV with an

inclination.

• This speaker features a magnetically shielded

design, but there is still a chance that placing it too

close to a TV set might impair picture color or create

a buzzing noise. Should this happen, move the

speaker away from the TV set.

Front

Surround

Subwoofer

SUPPLIED ACCESSORIES

Fastener (4 sets)

Fastener

Soavo-900C

Peal off

the seal.

When placing the speaker on top of the TV

rack, etc.

Attach the provided fasteners at two points on the bottom

of the speaker and on top of the TV rack.

• Thoroughly wipe clean the surface where the

fastener is to be applied. Note that adhesive

strength is weakened if the surface is dirty, oily or

wet and that this may cause the center speaker to

drop.

• Do not touch the adhesive surface after peeling off

the seal as this will weaken its adhesive strength.

01_En_Soavo-900C_URGT.p65 7/31/06, 9:11 AM2

English

• Connect the screw-type terminals at the rear of the

speaker to the speaker terminals of the amplifier with the

speaker cable (sold separately).

• Connect the (+) terminals on the amplifier and the

speaker using one side of the cable. Connect the

(–) terminals on both components using the other side of

the cable.

• Connect the speaker to the center terminals of your

amplifier, making sure not to reverse the polarity (+, –). If

the speaker is connected with reversed polarity, the

sound will be unnatural and lack bass.

How to connect:

1 Loosen the knob.

2 Remove the insulation coating at the extremity of each

speaker cable by twisting the coating off.

3 Insert the bare wire in to the hole.

4 Tighten the knob and secure the cable.

Test the firmness of the connection by pulling lightly on

the cable at the terminal.

Notes

•

Do not let the bare speaker wires touch each other

as this could damage the speaker or the amplifier, or

both of them.

• Do not insert the insulation coating into the hole.

The sound may not be produced.

When using a banana plug

1 Unscrew the terminal knob.

2 Remove the cover by pulling it toward you.

Banana plug

CONNECTION TO YOUR AMPLIFIER

Before making connection, make sure that the amplifier is switched off.

–

CENTER

Amplifier

Soavo-900C

Tighten

Black (–)

Red (+)

Loosen

Insulation coating

Bare wire

3 Tighten the terminal knob.

4 Simply insert the banana plug into the terminal.

10 mm

(3/8")

Good No Good

01_En_Soavo-900C_URGT.p65 7/31/06, 9:11 AM3

SPECIFICATIONS

Type ............................. 2-way bass reflex speaker system

Magnetic shielding type

Driver ...................................... 13 cm (5”) cone woofer x 2

3 cm (1”) Aluminum dome tweeter

Impedance ................................................................... 6 Ω

Frequency Response ................. 56 Hz to 50 kHz (–10 dB)

to 100 kHz (–30 dB)

Nominal Input Power .................................................. 40 W

Maximum Input Power ............................................. 200 W

Sensitivity .................................................. 89 dB/2.83 V/m

Crossover Frequency ................................................ 3 kHz

Dimensions (W x H x D) ..................... 500 x 170 x 271 mm

(19-11/16” x 6-11/16” x 10-11/16”)

Weight ................................................... 8.6 kg (18.15 lbs.)

• Specifications subject to change without notice due to

product improvements.

• Care should be taken not to exceed the input power

values noted above.

ATTACHING THE FRONT COVER

The speaker and the front cover are packed separately.

To attach the front cover, line up the four salients (magnet)

on the reverse side of the front cover with the four

corresponding pegs.

Notes

• When the cover is not attached, take care not to

touch the speaker units with your hands or to exert

excessive force with tools.

• There are magnets on the reverse side of the front

cover. Do not place the front cover close to objects

that might be affected by magnets, such as TVs,

clocks, magnetic cards, diskettes etc. when you

don’t use it.

Taking care of the speaker

When you wipe this unit, do not use chemical solvents

(ex. alcohol or thinners etc.); this might damage the

finish. Use a clean, dry cloth. For heavy dirt, dampen a

soft cloth in detergent diluted with the water, wring it out,

and then clean this unit up with a soft cloth.

01_En_Soavo-900C_URGT.p65 7/31/06, 9:11 AM4

Yamaha Soavo-900C Инструкция по применению

Похожие модели бренда