MMF-SWP1 Installation Guide
MMF-SWP1
Remove 17 screws (rear ×3, both sides ×10, top ×4).
Use a #1 screwdriver to remove the four top screws, and a #2 screwdriver to remove
the remaining screws.
1
Remove the chassis cover.
2
Remove the front MMF cover. Use a Star screwdriver.
3
Remove the protective cap from the opticalCON connector, and attach it using the
screws that were attached to the MMF cover.
4
Remove the protective cap from the MMF unit, and insert it until the MMF unit clicks
into place. Set the lever to the upward position. If it is in the downward position,
it will not be locked, possibly allowing the MMF unit to become detached by an impact.
5
ZR15950
JAEN
Thank you for choosing the Yamaha MMF-SWP1 (optical option
unit) for Yamaha SWP1.
Ask an authorized Yamaha service engineer to install the unit.
Do not install the unit yourself.
Information
This is a class A product. In a domestic environment this product
may cause radio interference in which case the user may be
required to take adequate measures. (CISPR22)
Using the Screwdrivers
When you install the unit, you use the screwdrivers following:
Phillips screwdrivers (#1 and #2)
Star screwdriver (T10)
Laser label (Use only SMF1-8.)
Installing the unit (For only authorized Yamaha
service engineers)
The power cord and external power supply must be
disconnected before installing the unit.
Remove the protective cap from the optical ber, pass the optical ber below the
existing optical ber, and insert it into the MMF unit until it clicks into place.
6
Open the lid, pass the optical ber through the hook, and close the lid.
If installing in the SWP1-8, connect the wiring so that front panel port numbers 9 and 10 match the
printed numbers 9 and 10 of the bottom chassis.
7
Insert the optical ber into the opticalCON port until it clicks into place.
8
Replace the cover on the chassis, and attach the rackmount hardware and screws that
you removed in step 2.
Attach the screws in numerical order. Screws with the same number may be attached
in any order within that number.
9
In the case of the SWP1-8, ax the laser label in the location shown by the shading.
10
Yamaha Global Site
http://www.yamaha.com/
Yamaha Downloads
http://download.yamaha.com/
Manual Development Department
2015 © Yamaha Corporation
Published 11/2015
MWHD-A0
Printed in China
1 22
3
3
5
55
5
5 5
3
3
4
4 4 4
保护环境
如果需要废弃设备时，请与本地相关机构联系，获取正确的废弃方法。
请勿将设备随意丢弃或作为生活垃圾处理。
Важное примечание: Информация об условиях Гарантии для Клиентов
в Российской Федерации [Русский]
Для получения подробной информации об условиях Гарантии на
продукцию Yamaha в России, условиях гарантийного обслуживания,
пожалуйста, посетите веб-сайт по адресу ниже (на сайте доступен
файл с условиями для скачивания и печати) или обратитесь в офис
представительства Yamaha в России.
http://ru.yamaha.com/ru/support/
NOTE
NOTE
本表格依据 SJ/T 11364 的规定编制。
○: 表示该有害物质在该部件所有均质材料中的含量均在 GB/T 26572规定的
限量要求以下。
×: 表示该有害物质至少在该部件的某一均质材料中的含量超出 GB/T 26572
规定的限量要求。
部件名称
电缆类
有害物质
铅(Pb) 汞(Hg) 镉(Cd)
六价铬
(Cr(VI))
多溴联苯
(PBB)
多溴二苯醚
(PBDE)
产品中有害物质的名称及含量
此标识适用于在中华人民共和国销售的电子信息产品。
标识中间的数字为环保使用期限的年数。
Information for Users on Collection and Disposal of Old Equipment
This symbol on the products, packaging, and/or accompanying
documents means that used electrical and electronic products
should not be mixed with general household waste.
For proper treatment, recovery and recycling of old products,
please take them to applicable collection points, in accordance
with your national legislation and the Directives 2002/96/EC.
By disposing of these products correctly, you will help to save
valuable resources and prevent any potential negative effects on
human health and the environment which could otherwise arise
from inappropriate waste handling.
For more information about collection and recycling of old
products, please contact your local municipality, your waste
disposal service or the point of sale where you purchased the
items.
[For business users in the European Union]
If you wish to discard electrical and electronic equipment, please
contact your dealer or supplier for further information.
[Information on Disposal in other Countries outside the
European Union]
This symbol is only valid in the European Union. If you wish to
discard these items, please contact your local authorities or dealer
and ask for the correct method of disposal.
(weee_eu_en_01)
/